Tool helps remove or add traffic lights at the intersection. Traffic lights can be added and removed any crossroads include highway and off- and on ramps of them.
There are many ways to operate this tool:
Users can click the menu button in the tool path beneath roads Button decommissioning of the road menuActivated button in the menu path Or users can use the shortcut Ctrl + T. This also works like pressing the button. If the menu path is not open when you press the shortcut menu opens. Press Ctrl + T again will deselect tools Convert traffic lights and close the menu path. The keyboard shortcut Ctrl + Shift + T will enable the tools too, but not open the menu path. That means that there is no visual indication as a strong push button, but this tool is fully active. Press Ctrl + Shift + T again (or Ctrl + T) to disable engines and reenables Traffic Light tool last used. This shortcut is therefore very useful for quick changes. Press the shortcut key while the unit is operating road will act as clicking or pressing Ctrl + T – with one exception: Press Ctrl + Shift + T while the engine is operating in the menu path will not close the menu (like Ctrl + T) but chose the road-building tool.
So this shortcut similar behavior mod Turn off traffic lights before a node is added. Cities Skylines When this tool is active, the user can hover over an intersection. This intersection will be highlighted. The highlight for the current status of traffic lights: green light means the traffic light while dark blue shows that there are no traffic lights. Notify same information is shown in the tooltip. Add it will display the original state of the traffic lights on this intersection. To turn off traffic lights left click on an intersection. Or the user can reset the traffic lights to its original state via a right click.
Ctrl + T: Enable / Disable TTL by selecting the menu button in the path TTL Ctrl + Shift + T: Enable / Disable TTL without using the buttons Left Mouse: Turn off traffic light Right Click: Reset the traffic lights to the default state PageDown: Activation mode to switch the light in the tunnel PageUp: Activation mode to switch the light on the ground PageUp + PageDown: Activation mode to convert light above and below ground
In version 0.4.0 batch commands (add / remove / reset all the traffic lights) were introduced. These commands can be accessed via a single click on the Toggle button in the menu Traffic Light road. Please note: The command is executed right click button is clicked – there is no return.
In version 0.7.0 toggling the light in the tunnel (city skyscraper :. v 1:10) is possible. Tunneling through PageDown, go up again through PageUp, or using PageUp + PageDown if you want to convert light above and below ground on simultaneously.